Mounting The Cutting Decks To The Traction Unit; Servicing The Blade Plane - Toro Groundsmaster 3500-D Operator's Manual

Figure 68
1. Motor-mounting screws
3. Remove the lynch pin or retaining nut securing
the deck carrier frame to the lift-arm-pivot pin
(Figure 69).
g031644
1. Lynch pin
4. Roll the cutting deck away from the traction unit.
Mounting the Cutting Decks
to the Traction Unit
1. Perform the pre-maintenance procedure; refer
to Preparing the Machine for Maintenance (page
36).
2. Move the cutting deck into position in front of
the traction unit.
3. Slide the deck-carrier frame onto the
lift-arm-pivot pin and secure it with the lynch pin
or retaining nut
4. Using the hydraulic-motor-mounting screws,
install the hydraulic motor to the deck
68).
Note:
Ensure that the O-ring is properly
positioned and not damaged.
5. Grease the spindle.

Servicing the Blade Plane

The rotary deck comes from the factory preset at 5
cm (2 inches) height-of-cut and blade rake of 7.9 mm
(0.31 inch). The left and right heights of cut are also
preset to within ± 0.7 mm (0.03 inch) of the other.
The cutting deck is designed to withstand blade
impacts without deforming the chamber. If the blade
strikes a solid object, inspect the blade for damage
and the blade plane for accuracy.
54
Figure 69
2. Lift-arm-pivot pin
(Figure 69).
g031645
(Figure