Upper Case And Control Panel Removal - Epson Stylus COLOR 900 Service Manual

EPSON Stylus COLOR 900/900N

4.2.1 Upper Case and Control Panel Removal

1. Remove the paper support.
2. Open the cover.
3. Open the output tray.
Screws securing
Paper Support
the Upper Case
Screws securing the
Front Case
Figure 4-2. Upper Case Removal
Screws securing
the Control Panel
Control
Panel
Output Tray
Front Case
Chapter 4 Disassembly and Assembly
4. Remove the screw on the left that secures the front case to the
printer mechanism, and then pull the front case forward and remove
it from the printer.
5. Pull the output tray to the left and remove it.
6. Remove the two screws securing the control panel to the printer
mechanism to release the control panel. Then disconnect the FFC
from the control panel and remove the control panel from the printer.
See Figure 4-3.
7. Remove the four screws securing the upper case.
C H E C K
During assembly, place the machine screw
P O I N T
(metal screw) in the rear right of the upper case.
The other three screws are plastic screws.
8. Lift up the front edge of the upper case and then remove the upper
case.
C A U T I O N Avoid catching the upper case on the ink cartridge
clamps during removal. If an ink cartridge clamp lifts
up, it may let air into the ink cartridge.
91