Epson Stylus COLOR 900 Service Manual page 107

EPSON Stylus COLOR 900/900N
C H E C K
During assembly, you must orient both hopper release
P O I N T
cams so their notches face left as shown below. Also,
you must install them so they point in the same
direction as the flat part of the feed rollers as shown:
Cam (white
plastic)
Notch faces to the left
when viewing ASF unit
front the front
Figure 4-24. Hopper Release Cam Orientation
3. Remove the E-clip located just to the inside of the left hopper
release cam, as shown below.
E-Clip
ASF Roller Shaft
Figure 4-25. E-Clip Removal
Feed Roller (black rubber)
Chapter 4 Disassembly and Assembly
4. Slide the shaft to the left as far as it goes.
5. Remove the detection wheel by releasing the tab that secures it to
the left end of the shaft, as shown below.
Figure 4-26. Detection Wheel Removal
C H E C K
During assembly, make sure that the hole in the
P O I N T
detection wheel faces the same direction as the
hopper release cam.
6. Slide the shaft all the way to the right. Then remove the E-clip
located between the right feed roller (loading or LD roller) and the
right side of the ASF frame.
7. Slide the shaft out of the ASF unit.
Roller Shaft
104