Epson Stylus COLOR 900 Service Manual page 106

EPSON Stylus COLOR 900/900N
4.2.8.5 Auto Sheet Feeder (ASF) Unit Removal
1. Remove the pump/ASF motor together with the switching
mechanism frame. (See page
2. Remove the E-clip securing the ASF drive gear located on the side
of the ASF unit.
3. Remove the three screws securing the ASF unit to the frame, as
shown below.
Paper
Support Lever
ASF Drive Gear
Figure 4-22. ASF Unit Removal
C A U T I O N When installing the ASF unit, be sure to insert the
screws in their correct locations:
T
Screw with a flat head: on the left side of the ASF
(viewing the printer from the front).
T
Screw with a washer: on the right side of the ASF.
T
Large plastic screw: into the side of the ASF.
102.)
S cre w s secu ring the AS F U nit
Chapter 4 Disassembly and Assembly
4. Slide the ASF unit toward the left side of the printer to remove the
ASF drive gear. Then raise the paper support lever and, while
holding it up and out of the way, remove the ASF unit.
4.2.8.6 ASF Disassembly
1. Remove the ASF unit. (See
2. Remove the right hopper release cam.
Roller Shaft
Hopper Release Cam (Right)
Figure 4-23. Removing the Hopper Release Cam
page 103.)
103