Upper Case Removal - Epson Stylus Pro Service Manual

Stylus Pro Service Manual

3.2.1 Upper Case Removal

1. 1. Remove the printer cover by releasing the 2 tabs holding it to the upper case.
2. Remove the paper support by releasing the 2 tabs holding it to the lower case.
3. Move the carriage to the center while pressing the carriage lock lever.
4. Remove the control panel. (Release the tab by inserting a screwdriver into the hole in the upper case, as
shown in the figure below.) At this time, disconnect the connector on the C137 PNL Board.
Carriage Lock Lever
2. Move
5. Remove 2 CBB (M3 11) screws securing the upper case to the lower case.
6. Release 2 tabs by inserting a flathead screwdriver into the holes at the bottom of the lower case, as
shown in the figure below.
7. Remove the upper case by lifting the front side.
Hold the upper case firmly and pull it to remove it, while you release the tabs.
Rev.A
1. Press
Figure 3-2. C137 Control Panel Removal
Figure 3-3. Upper Case Removal
Disassembly and Assembly
Printer Cover
CBB(M3x11)
Control Panel
3-3