Setup; Installing The Roller; Installing The Ball Studs; Installing The Hoop Link, Offset Link, Or Chain Link - Toro Greensmaster 3150 Series Operator's Manual

Setup

Media and Additional Parts
Description
Ball stud
Operator's Manual
Parts catalog

Installing the Roller

The cutting unit is shipped without a front roller.
Obtain a roller from your dealer and install it on the
cutting unit, as follows:
1. Remove the plow bolt, washer, and flange nut
securing one of the height-of-cut arms to the
cutting unit side plate
1. Height-of-cut arm
2. Adjusting screw
3. Plow bolt
2. Loosen the roller-mounting screws in the
height-of-cut arms
3. Slide the roller shaft into the height-of-cut arm
on the opposite end of the cutting unit
4. Slide the height-of-cut arm onto the roller shaft
(Figure 3).
5. Loosely secure the roller to the cutting unit with
the height-of-cut arm and fasteners previously
removed (Figure
(Figure 3).
Figure 3
4. Washer
5. Flange nut
6. Roller-mounting screw
(Figure 3).
(Figure
3).
Qty.
2 Mount this to the roller.
1
Read before installing and operating the cutting unit.
1 Use this to reference part numbers.
6. Center the roller between the height-of-cut arms.
7. Tighten the roller-mounting screws
8. Adjust to the desired height-of-cut and tighten
the height-of-cut arm mounting fasteners.

Installing the Ball Studs

Install a ball stud on each end of the front roller
4).
1. Ball stud
g016936
Installing the Hoop Link,
Offset Link, or Chain Link
For cutting units mounting on a traction unit with a
serial number prior to 240000001, obtain and install
the proper lift link as follows:
Note:
The 2 bolts used to mount the lift link are
shipped installed on the cutting unit.
3).
•
For Greensmaster 3120 and 3150 traction units,
install the hoop link supplied with the traction unit.
Install the hoop link to the top of the cutting unit
with 2 bolts. Torque the bolts to 34 to 40 N∙m (25
to 30 ft-lb)
5
Use
Figure 4
(Figure 5).
(Figure 3).
(Figure
g020075