Adjusting The Cutting Unit - Toro Greensmaster 3150 Series Operator's Manual

1. Drive spline
2. Motor mount
5. On the right end of the cutting unit, apply a light
coating of oil to the O-ring and install the counter
weight with the bolts previously removed
9). Torque the bolts to 16 to 20 N∙m (12 to 15
ft-lb).
1. Counter weight

Adjusting the Cutting Unit

1. Support the cutting unit; refer to
Cutting Unit (page
2. Adjust the bedknife to the reel; refer to
the Bedknife-to-Reel Contact (page
3. Adjust the rear roller height; refer to
the Rear-Roller Height (page
4. Adjust the height of cut; refer to
Height of Cut (page
5. Adjust the cut-off bar; refer to
Cut-Off Bar (page
Figure 8
3. Allen head bolts
Figure 9
Supporting the
9).
Adjusting
9).
Adjusting
11).
Adjusting the
12).
Adjusting the
13).
g016515
(Figure
g016506
7