Product Overview; Specifications; Attachments/Accessories; Operation - Toro Greensmaster 3150 Series Operator's Manual

Product Overview

Specifications

Tractors
Height of Cut
Height-of-Cut Range
Cutting Width
Reel Bearings
Rollers
Bedknife
Bedknife Adjustment
Grass Shield
Counterweight
Net Weight

Attachments/Accessories

A selection of Toro approved attachments and accessories is available for use with the machine to enhance
and expand its capabilities. Contact your Authorized Service Dealer or Distributor or go to www.Toro.com for a
list of all approved attachments and accessories.
To ensure optimum performance and continued safety certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement parts and accessories made by other manufacturers could be
dangerous, and such use could void the product warranty.

Operation

Refer to your traction unit Operator's Manual for detailed operation instructions. Before using the cutting unit
each day, adjust the bedknife; refer to
by cutting a test swath before using the cutting unit on a green to ensure that the finished cut is correct.
Greensmaster 3120, 3150, 3250-D, and 3150-Q Traction Units.
Adjust on the front roller using 2 vertical bolts and held 2 locking bolts.
Standard bench height-of-cut range is 1.6 mm (0.062 inch) to 12.7 mm (0.500 inch). Bench
height-of-cut range with the High Height of Cut Kit installed is 7 mm (0.285 inch) to 25 mm
(1.00 inch). Effective height of cut may vary depending on turf conditions, type of bedknife,
rollers, and attachments installed.
53 cm (21 inches)
Two sealed stainless steel, deep groove ball bearings
The rear roller is a 5.1 cm (2 inch) diameter steel full roller.
Replaceable single edged, high carbon steel bedknife is fastened to a machined cast iron
bedbar with 13 bolts
Dual-bolt adjustment to the reel; detents corresponding to 0.018 mm (0.0007 inch) bedknife
movement for each indexed position
Non-adjustable shield with adjustable cut-off bar to improve grass discharge from reel in
wet conditions
A cast iron weight mounted opposite to the drive motor balances the cutting unit.
8 Blade—30 kg (65 lb), 11 Blade—31 kg (68 lb), 14 Blade—32 kg (71 lb)
Adjusting the Bedknife-to-Reel Contact (page
8
9). Test the quality of cut