Setup; Assembling The Handle - Toro HoverPro 450 Operator's Manual

Setup

1

Assembling the Handle

No Parts Required
Procedure
1. Slide 2 bushes into the frame.
3
6
g017333
1. Lower handle
2. Bushes
3. Nut
2. Place the lower handle between the bushes and secure
it with 1 handlebar bolt, 2 washers, and 1 nut.
Note: Place the lower handle between the bushes with
the kick stop assembly on the right hand side.
3. Repeat for the opposite side.
4. Align the holes on the upper handle with the lower
handle.
1
2
4
Figure 3
4. Frame
5. Bolt
6. Washers
5
4
1. Upper handle
2. Hand wheel
3. Washer
5. Fit the U bolt through the upper and lower handle and
secure it with a washer and a hand wheel.
6. Attach the throttle assembly to the outside of the
handlebar and secure it with a nut and a pan screw.
5
7
g017328
Figure 4
4. U bolt
5. Lower handle
Figure 5
1
3
2