Hitachi HF-W100E Instruction Manual page 25

(7) WARRANTY
<Specifications>
• The Manufacturer cannot guarantee for damage to data or application software caused by
hardware damage to the equipment.
• Use an operating system specified by the Manufacturer. The Manufacturer cannot
guarantee proper operation of the equipment if you use an operating system not specified
by the Manufacturer.
2. NETWORK
<Precautions>
• When you send a Magic Packet™ frame, make sure the standby lamp of the equipment is
on. If you send a Magic Packet™ frame when the power is about to be turned off after an
OS shutdown, the equipment may restart without being turned off or wake on LAN
(WOL) may not function at all. (See "2.6.2 Turning on the power using the LAN".)
<Specifications>
• Depending on the status of the network, Magic Packet™ frames can be lost. In order to
avoid this, set up the system so that Magic Packet™ frames can be propagated without
loss. (See "2.6.2 Turning on the power using the LAN".)
• Even though a network drive may be configured to be reconnected at logon, sometimes
the reconnection may fail. If this happens, log on again or use the "net use" command to
establish the connection.
For information about the net use command, see the Windows® help.
• If the settings of the hub and the network adapter do not match, the performance of the
network adapter may be compromised or the network adapter may not work properly. (See
"2.7 Setting Up the LAN Interface".)
• The electric potential difference between units can generate heat. Therefore, do not use
twisted-pair Ethernet cables (such as category 5 or STP cables) for network connections
other than the ones specified in "5.5.1 Connector specifications".
C-5