Table of Contents
Advertisement
®
ABB i-bus
EIB / KNX
3.2.2
Logic
© 2004 ABB STOTZ-KONTAKT GmbH
Application and planning
ON/OFF delay
The ON/OFF delay causes the output to be switched on or off with a delay.
Output
ON
OFF
Object "Switch"
After a switching command, the delay period T
elapsed, the output carries out the switching command.
Note:
If the device receives an OFF command during the ON delay
period T
Application: e.g. dynamic lightscene, in which luminaires are connected in
sequence
Flashing
The output can flash by switching on and off periodically.
Output
ON
OFF
Object "Switch"
The ON time (T
) and OFF time (T
ON
parameterised.
Note:
Please note that the maximum number of switching operations
is limited for the Switch Actuator Module SA/M 2.6.1. The
number of switching operations is unlimited for the Electronic
Switch Actuator Module.
With the "Logic" function, it is possible to link the switching of the output with
certain conditions. Two logic objects are available:
Object "Switch"
Object "Logical
connection 1"
Object "Logical
connection 2"
First, the object "Switch" is evaluated together with the object "Logical
connection 1". The result is linked with the object "Logical connection 2".
The following logic functions are possible:
T
D1
„1"
, the ON command is rejected.
D1
T
T
ON
OFF
"1"
) during the flashing can be
OFF
Logic
operation
T
D0
"0"
or T
starts. Once it has
D1
D0
"0"
Logic
operation
Output
13
Advertisement
Table of Contents
