Controls System Maintenance; Checking The Forward/Reverse Travel Pedal Action; Checking The Operator-Presence-Seat Switch; Checking The Cutter-Drive-Interlock Switch - Toro LT-F3000 Operator's Manual

Controls System
Maintenance
Checking the
Forward/Reverse Travel
Pedal Action
With the engine shut off, operate the forward and
reverse travel pedals through the full range of
articulation and ensure that the mechanism returns
freely to the N position.
EUTRAL
Checking the
Operator-Presence-Seat
Switch
Service Interval: Before each use or daily
1. Sit on the operator seat and start the engine.
2. Lower the cutting units to the ground.
3. Engage the cutter drive.
4. Rise from the operator seat and check that the
flail rotors come to a stop after an initial 0.5 to 1
second delay.
Checking the
Cutter-Drive-Interlock
Switch
1. Shut off the engine.
2. Turn the cutter-drive switch to the O
and turn the ignition key to position I. The cutting
units drive switch indicator light should not
illuminate.
3. Turn the switch to the on position. The indicator
light should illuminate and the engine should not
start when the ignition key is turned.
Checking the
Parking-Brake-Interlock
Switch
1. Shut off the engine.
2. Engage the parking brake.
3. Turn the ignition key to position I. The parking
brake indicator light should illuminate.
4. Disengage the parking brake. The indicator light
should go out and the engine should not start
when the ignition key is turned.
5. Set the parking brake, sit on the operator seat,
and start the engine.
6. Release the parking brake.
7. Rise from the operator seat and check that the
engine shuts off.
Checking the
Transmission-Neutral-Interlock
Switch
1. Shut off the engine.
2. Remove your foot from the forward/reverse
travel pedals.
3. Turn the ignition key to position I and the
transmission neutral indicator light should
illuminate.
4. Apply light pressure to the travel pedals in a
forward and reverse direction to check that the
indicator light turns off.
Note:
Take extreme care to ensure that the area
around the mower is clear before checking to see if
position
FF
the engine starts under this condition.
46