Table of Contents
Advertisement
Controls System
Maintenance
Adjusting the Control Lever
Neutral Interlock Switch
1. Stop the machine, move the deck lift switch fully into
the neutral-locked position, set the parking brake, and
remove the ignition key.
2. Remove the bolts securing the front panel and remove
the panel
(Figure
53).
2
1
Figure 53
1. Bolts
2. Seat plate
3. Loosen the 2 screws securing the interlock switch
(Figure
54).
1. Control lever
2. Neutral interlock switch
4. Holding the control lever against the frame, move the
5. Secure the switch.
G020875
6. Repeat steps
7. Install the front panel.
Adjusting the Control Lever
Neutral Return
If the motion control levers do not align with the neutral slots
when released from the reverse drive position, adjustment is
required. Adjust each lever, spring, and rod separately.
1. Disengage the PTO, move the control lever to the
2. Move the throttle lever to the Slow position, stop the
3. Remove the bolts securing the front panel and remove
47
Figure 54
switch toward the lever until the distance between lever
and switch body is 0.4 to 1 mm (0.015 to 0.045 inch)
(Figure
54).
3
to
5
for the other lever.
neutral locked position, and set the parking brake.
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
the panel
(Figure
55).
3. Screws
4. 0.4 to 1 mm (0.015 to
0.045 inch)
Advertisement
Table of Contents
