Fuel System Maintenance; Draining The Fuel Tank; Checking The Fuel Lines And Connections; Bleeding The Fuel System - Toro LT-F3000 Operator's Manual

1. Remove the drain plug
oil flow into a drain pan.
Figure 49
1. Oil-drain plug
2. When the oil stops, install the drain plug.
3. Remove the oil filter
Figure 50
1. Oil filter
4. Apply a light coat of clean oil to the new filter
seal.
5. Install the replacement oil filter to the filter
adapter. Turn the oil filter clockwise until the
rubber gasket contacts the filter adapter, then
tighten the filter an additional 1/2 turn.
Important:
Do not overtighten the filter.
6. Add oil to the crankcase; refer to
Engine-Oil Level (page
(Figure 49) and let the
(Figure 50).
Checking the
38).
Fuel System
Maintenance
DANGER
Under certain conditions, fuel and fuel vapors
are highly flammable and explosive. A fire or
explosion from fuel can burn you and others
and can cause property damage.
• Fill the fuel tank outdoors, in an open area,
when the engine is off and is cold. Wipe up
any fuel that spills.
• Do not fill the fuel tank completely full. Add
g008911
fuel to the fuel tank until the level is 25 mm
(1 inch) below the top of the tank, not the
filler neck. This empty space in the tank
allows the fuel to expand.
• Never smoke when handling fuel, and stay
away from an open flame or where fuel
fumes may be ignited by a spark.
• Store fuel in a clean, safety-approved
container and keep the cap in place.

Draining the Fuel Tank

Service Interval: Every 800 hours
Before storage
Drain and clean the fuel tank if the fuel system
becomes contaminated or if the machine is to be
stored for an extended period. Use clean fuel to flush
out the tank.
Checking the Fuel Lines
and Connections
g008912
Service Interval: Every 400 hours/Yearly (whichever
Check the fuel lines and connections. Inspect them
for deterioration, damage, or loose connections.

Bleeding the Fuel System

You must bleed the fuel system before starting the
engine if any of the following situations have occurred:
•
Initial start-up of a new machine.
•
Engine has ceased running due to lack of fuel.
•
Maintenance has been performed upon fuel
system components; i.e., filter replaced, separator
serviced, etc.
1. Park the machine on a level surface and ensure
that the fuel tank is at least half full.
39
comes first)