Toro LT-F3000 Operator's Manual page 13

Differential Lock
WARNING
The turning radius increases when the
differential lock is engaged. Using the
differential lock at high speed may lead to loss
of control and cause serious injury and/or
property damage.
Do not use the differential lock at high speed.
Use the differential lock to prevent excessive wheel
spin when the drive wheels lose traction. The
differential lock operates in both forward and reverse.
You can lock the differential while the machine is
traveling slowly. Engine power demand increases
when the differential is locked. Prevent excessive
power requirements by using the differential lock only
at low speed.
To lock the differential, press the differential-lock
switch.
To unlock the differential, release the differential-lock
switch.
Cutting-Units Position Controls
Use the cutting-units position controls to independently
raise and lower the cutting units; refer to
the Position of the Individual Cutting Units (page
Transport Latches
Always raise the cutting units to the T
position and secure with the transport latches and
safety locks when travelling between work areas
(Figure 10).
Cutting-Unit-Drive Switch
To engage the cutting unit drive, refer to
Cutting Unit Drive (page
Note:
O
FF
Controlling
26).
Adjustable Steering Column
Adjustment of the steering wheel and steering column
should only be carried out when the mower is at a
RANSPORT
standstill with the parking brake engaged.
1.
2.
13
Figure 10
27).
Always put the cutting-unit-drive switch in the
position when travelling between work areas.
To tilt the steering wheel, press the foot pedal
down.
Position the steering tower to the most
comfortable position and release the pedal
(Figure 11).
Figure 11
g014548
Engaging the
g014549