Canceling Print Operations - Sony SnapLab UP-CR20L Operating Instructions Manual

2
Touch the [Print Start] button.
A numeric keypad appears for inputting the password
(budget code).
3
Store staff inputs the password and touches the [OK]
key.
The staff member uses the numeric keypad displayed
on the screen to enter a four-digit password (either the
checkout password or the administrator password).
Memo
• If using budget codes, input the budget code instead
of a password and then touch the [OK] button.
• If using a memory card to input the password,
simply insert the memory card when the password
input screen appears.
If the correct password is input, printing begins.
When a message prompting you to remove the
memory card appears, remove the memory card from
the slot.
Note
Do not remove the memory card until the unit prompts
you to do so. Removing the memory card at the wrong
time could result in the loss or damage of image data.
In addition, removing the expansion CompactFlash
card while printing is in progress may prevent printing
from continuing normally.
64

Canceling Print Operations

Canceling Print
Operations
To cancel a print operation while it is in progress (the
progress bar is displayed on the screen), perform the
following procedure.
1
Touch the top left corner of the print operation screen
(progress bar displayed) twice in succession.
The password entry screen appears.
2
Enter the administrator password or checkout
password using the numeric keypad, and touch [OK].