Sony SnapLab UP-CR20L Operating Instructions Manual page 28

2
Pull the ribbon on the white spool, attach one edge of
a strip of adhesive tape along the entire length of the
ribbon's end, and then attach the other edge of the tape
to the ribbon on the black spool.
B Attach the adhesive tape along
A Wind the
spool to feed
the ribbon out.
3
Remove any slack from the ribbon.
Wind the black spool to remove any slack.
Note
Be sure to wind the taped portion completely onto the
black spool so that the tape is not exposed.
4
Hold the center of the ribbon tray, and load it into the
unit.
Note
Always hold the center of the ribbon tray when loading
it into the unit. If you hold the tray by any other part,
your fingers may get caught while inserting the tray
and injuries may result.
28
Replacing the Paper Roll and Ink Ribbon
the entire length of the white
spool's ribbon end, and attach it to
the ribbon on the black spool.
5
Close the ribbon door.
Depending on the position of the ribbon break, a single
printout's worth of ribbon may be lost.