Table of Contents
Advertisement
NOTICE – Equipment damage: Do not over-tighten the terminal connector screws as this may
damage the wires.
Reinsert the terminal connector in the J7 terminal block.
IMPORTANT NOTE: The XSeries
See
Additional
Install the antenna to support onboard Bluetooth
Use onboard connector ANT-1 (J42) to connect the antenna.
Use the cap to isolate the unused antenna connector (ANT-2).
Place communication equipment, such as a radio in the communication compartment, inside of the
enclosure. For radios with serial interfaces, use the available onboard COMM port. COMM1 port is
preconfigured for remote communication and can be used for the radio. See section
description.
3 8 | XSE RI ES G5 | 2 10 6 02 6MNAA
G5
Wi-Fi Kit 2106049AIAB is required for antenna installation.
information.
®
and Wi-Fi
®
wireless interfaces.
5.1 COMM port
Advertisement
Table of Contents
