16
C U S T O M A P P L I C AT I O N E D I T O R M A N U A L
—
Creating the first application
In this section you learn how to create an application step by step from scratch.
Preconditions:
FIM UMC Edition installed on your PC.
Communication interfaces depending on requirements
• Serial point-to-point
• Profibus DP
—
Enabling the Custom Application Editor
After starting up FIM UMC Edition and selecting in Device Settings the Parametrize mode, the Custom Application Editor can
be enabled by checking the parameter "Enable custom logic" on the tab "General Settings". This brings up two additional tab
cards, one with the application editor and a tab card for configuring the function block for triggering external warnings and
trips.
Your display should look as shown below.
Device Tree
USB cable connected to the UMC100-PAN control panel
Communication interface UTP22-FBP.0 for Profibus and
UMC100.3 with Profibus interface PDP32.0
Configuration
Application
Check box to
enable the custom
application mode.