Umc Output Function Blocks - ABB UMC100.3 Manual

C U S T O M A P P L I C AT I O N E D I T O R M A N U A L
—
Function block reference
—

UMC Output Function Blocks

The function blocks described in this section represent the different outputs of the UMC100 device.
• Cyclic fieldbus monitoring telegram
Word Byte
0 0
1
1 2
3
2 4
5
3 6
7
4 8
9
5 10
11
6 12
13
7 14
15
• Acyclic fieldbus monitoring telegram
• LEDs on the LCD panel
The digital outputs of the UMC100 are only accessible via the Control Function blocks which are described in section "Motor
Management" of the UMC100 manual.
—
Binary Monitoring
The function bocks "Binary Monitoring 0 ... 5" provide access to the monitoring bytes 0 ... 5 cyclically sent via fieldbus (e.g.
PROFIBUS). Monitoring data is sent from the UMC to the fieldbus master (e.g. a PLC).
Function Block
Inputs (from top to bottom)
Outputs
Parameters
Function Block
Binary Monitoring 0
Binary Monitoring 1
Analog Monitoring 0
Binary Monitoring 2
Binary Monitoring 3
Binary Monitoring 4
Binary Monitoring 5
Signal Name
In 0 ... In7: The 8 bits of the monitoring byte 0, 1, 2, 3, 4 or 5
-
-
Mapping between data in the cyclic monitoring telegramm
and the function blocks.
31
Data Type
-
-