Reusing Existing Solutions - ABB UMC100.3 Manual

C U S T O M A P P L I C AT I O N E D I T O R M A N U A L
—

Reusing existing solutions

To reuse existing solutions the following options exist:
• Import of a complete application which was previously exported from another project. This allows to reuse complete appli-
cations. Use the toolbar buttons to carry out the import and export. The imported application can now be adapted if nec-
essary.
• Copy parts of an application and paste it into another application. This allows you to reuse parts of an application.
• Copy and paste is possible between two devices within one project and also between different projects. In the latter case
both projects must be opened i.e. Asset Vision Basic must be started twice.
Make sure that the application or application parts you reuse are compatible with the UMC100 firmware
version in use. See section "Backwards compatibilty" at the beginning of this manual for more information.
There is a reference application for each of the built-in control functions.
—
Example of a Direct Starter
The following diagram shows the complete application of a direct starter. On the left side of the diagram the function blocks
are placed that deliver the inputs from the different control sources (bus, LCD panel, DI). In the middle the control place
selection takes place. The start/stop signals are then connected to the control function block. On the right side of the
diagram the function blocks responsible for monitoring (bus, LCD panel, DO) are placed
23