Table of Contents
Advertisement
microHAM © 2006 All rights reserved
DVK TAB
MK2R allows recording and playing nine voice messages per bank and an unlimited number of banks
(limited only by the capacity of the computer hard disk). Banks can be managed with Rename, Add and
Remove buttons. Rename to rename the current bank, Add to create a new bank, and Remove to delete
the current bank. Bank selection is provided by Bank box.
Each memory may repeat with a programmable delay
(loop) or can be chained with another memory using
external keyboard or keypad. Keyboard can be in
follow radio mode which is recommended or in
manual mode with the mode selected with the
Caps Lock key. When the keyboard is in follow radio
mode, the keyboard mode is set by the radio with TX
Focus. See: External Keyboard.
While DVK message is recorded or played, MK2R
forces "optimal" VOICE audio switching and uses DVK
mixer settings. When recording or playback is done,
Audio Mixer returns to the values adjusted at the Audio
Mixer tab. All this happen because DVK mixer settings
are not stored with presets but in the message banks.
This means each bank can have its own levels (slider
position). It also allows each bank to be configured for
the voice of each operator if MK2R is used in a multi-
operator setup.
DVK memories can be played back using the LPT signals (DVK 1-4 or DVK 1-6) generated by many
programs for controlling external DVK units. The external control signals are defined on the SO2R tab.
Router DVK uses the sound card defined on
the Audio Mixer Tab for VOICE: SC1 (MK2R)
or USB Voice CODEC (MK2R+).
REC MIC slider adjusts microphone level
during message recording.
TX R1 and R2 are separate level controls that
operate the same way as the TX VOICE
controls described at Audio Mixer tab.
If "On Air Recording" box is checked, the
microphone audio is automatically forwarded
to the transceiver with Transmit Focus
(selected transceiver) while message is
recorded.
54
Advertisement
Table of Contents
