Device Configuration Tabs - microHAM micro KEYER 2R Manual

There are ten (10) tabs for configuring MK2R. Each tab controls part of MK2R's functions. Except for the
CW Messages and FSK Messages tabs, any change is applied immediately to MK2R. Changes in the
Messages are only applied in response to the Store or Store All buttons.
Ports – used to assign virtual ports to the MK2R for use by applications
Audio Switching – used to configure microphone and sound card audio routing based on operator
preference, application sound card handling and operating mode
Audio Mixer – used to set levels of each channel of the sound cards or codecs.
PTT/FSK – used to configure T/R keying, keying sequencer and FSK keyboard functions
CW/WinKey – used to configure the internal CW keyer, PTT from the CW keyer, and side tone
CW Messages – used to configure internal CW messages
FSK Messages – used to configure internal FSK messages
DVK – used to record and adjust the level of the computer based voice keyer
SO2R – used to configure automatic control of essential functions for SO2R contesting
ACC – used for configuring accessory port
microHAM © 2006 All rights reserved

DEVICE CONFIGURATION TABS

27