microHAM micro KEYER 2R Manual page 14

(8) – MIX
Adjusts the level of mixing of audio from one ear into the other.
Mix is selected by the MODE button - when enabled the MIX light above the MODE button will light.
(9) – CW SPEED
Provides manual control of the WinKeyer2. Minimum and and Maximum speeds are defined by
software.
(10) – CW/FSK
RED color indicates the CW output to RADIO1 is active
GREEN color indicates the FSK output to RADIO1 is active
(11) – TX1
Adjusts drive level from the sound card or codec to RADIO1
(12) – PTT1/PTT2
RED color indicates PTT1 (RADIO1 front panel microphone jack PTT) is active
GREEN color indicates PTT2 (rear panel of RADIO1) is active
YELLOW color indicates both PTT1 + PTT2 are active
(13) – CW/FSK
RED color indicates the CW output to RADIO2 is active
GREEN color indicates the FSK output to RADIO2 is active
(14) – TX2
Adjusts drive level from the sound card or codec to RADIO2
(15) – PTT1/PTT2
RED color indicates when PTT1 (RADIO2 front panel microphone jack PTT) is active
GREEN color indicates when PTT2 (rear panel of RADIO2) is active
YELLOW color indicates when both PTT1 + PTT2 are active
(16) – RECORDING/DIGITAL LEFT
Controls the left channel audio level to SC2 Line In (MK2R) or "Digital" Audio Codec (MK2R+) for
audio recording or digital mode operation.
(17) – RECORDING/DIGITAL RIGHT
Controls the right channel audio level to SC2 Line In (MK2R) or "Digital" Audio Codec (MK2R+) for
audio recording or digital mode operation.
microHAM © 2006 All rights reserved
14