Switch Operation; Reset/Stop/Run Switch - Mitsubishi Electric MELSEC iQ-R Series User Manual

6.5

Switch Operation

This section explains the method for changing the operating status of a C Controller module.

RESET/STOP/RUN switch

The operating status of a C Controller module can be changed using the RESET/STOP/RUN switch.
• By setting the switch to the RUN position, the operating status is changed to RUN. (Status where output (Y) from a user
program and writing to the buffer memory are permitted)
• By setting the switch to the STOP position, the operating status is changed to STOP. (Status where output (Y) from a user
program and writing to the buffer memory are prohibited)
• Operating the switch with the following procedure resets a C Controller module.
Operate the RESET/STOP/RUN switch by fingertip.
Using tools such as a screwdriver may cause damage on the switch.
1.
Hold the RESET/STOP/RUN switch (1) in the RESET
position.
2.
Check that all LEDs turn OFF after the ERROR LED (2)
(2)
flashes several times.
3.
Release the RESET/STOP/RUN switch (1) and put it back to
the STOP position.
(1)
6 PROCEDURE BEFORE OPERATION
6.5 Switch Operation
6
41