Chapter 6 Procedure Before Operation - Mitsubishi Electric MELSEC iQ-R Series User Manual

6
PROCEDURE BEFORE OPERATION
This chapter shows the startup procedure and program execution of a C Controller module.
At the time of the first operation of a C Controller module, check that there is no error on the module using the hardware
diagnostic, then start the system.
Performing hardware diagnostics
1.
Mounting a C Controller module
Mount a power supply module and a C Controller module on a base unit. (MELSEC iQ-R Module Configuration Manual)
2.
Turning the power of the system ON
Check the wiring and the supply voltage of the power supply before the system is powered ON.
3.
Initializing the C Controller module
Initialize the C Controller module. (Page 32 Initialization)
4.
Performing hardware diagnostics
Check the hardware status of the C Controller module. (Page 34 Performing Hardware Diagnostics)
Starting the C Controller system
1.
Inserting an SD memory card
Insert an SD memory card to the C Controller module as necessary. (Page 39 Inserting and Removing SD Memory Card)
2.
Mounting modules and wiring for each device
Mount modules on the base unit, and wire for each device. (MELSEC iQ-R Module Configuration Manual)
3.
Turning the power of the system ON
Check the following items, and then turn ON the power supply.
• The wiring and supply voltage of the power supply are in the required range.
• The C Controller module is placed into the STOP state.
4.
Creating a project
Create a project for the C Controller module to be used with a personal computer on which CW Configurator has been
installed. (Page 44 Creating a Project)
5.
Connecting a personal computer to the C Controller module
Connect the personal computer on which CW Configurator has been installed to the C Controller module. (Page 44
Connecting to Personal Computer)
6.
Setting parameters
Set the system parameter, CPU parameter, and module parameter. (Page 45 Setting Parameters)
When using an SD memory card function, or when mounting an intelligent function module, also set parameters other than
the above. ( User's manual (Application) for each module)
7.
Writing parameters to the C Controller module
Write the parameters set with CW Configurator to the C Controller module. (Page 47 Writing Parameters to C Controller
Module)
8.
Resetting the C Controller system
Reset the system by one of the following methods.
• Turning the power of the system OFF and ON
• Resetting the C Controller module (Page 41 Switch Operation)
6 PROCEDURE BEFORE OPERATION
30