Mitsubishi Electric MELSEC iQ-R Series User Manual page 106

■Interrupt pointer setting
In CW Configurator, the setting for interrupt pointer is changed as follows.
• Setting the SI No. for an interrupt module is not required.
• "Interrupt pointer" of an interrupt module must be sequential numbers. (Set I51 to No.2 and I52 to No.3 when No.1 is set to
I50, for example.)
Setting/monitoring tools for the C Controller module
[Navigation window]  [Parameter]  [CCPU
Parameter]  [System settings] tab  [Intelligent
Function Module Setting]  [Interrupt event settings]
button
Intelligent function module tool
"Intelligent Function Module Tool" is changed to the window shown below.
Setting/monitoring tools for the C Controller module
[Tool]  [Intelligent Function Module Tool]  [(tool for
each module)]
APPX
104
Appendix 2 How to Use MELSEC-Q Series Modules
CW Configurator
[Navigation window]  [Parameter]  [Module
Information]  [(module name)]  [Module Parameter]
CW Configurator
[Tool]  [Module Tool List]  [Q Series]  [(tool for
each module)]