Making Network Settings - Sanyo DSR - 300 Instruction Manual

5 NETWORK SET
(when optional interface board is installed)
<MAIN MENU 2>

Making network settings

1
Press the [MENU] button twice.
The <MAIN MENU 2> screen appears.
2
Press the [
"5. NETWORK SET", then press the [ ]
button.
The <NETWORK SET> screen is displayed.
3
Move the cursor to "NETWORK
CONTROL" and press the [
buttons to set "ON", then press the [ ]
button.
(Example: ON)
[Settings] ( indicates default setting.)
Setting
Prevents operation of this unit via the network to which it is
OFF
connected.
English
] or [ ] button to select
] and [
Description
[ ] button
[
[MENU] button
[ ] button
Setting
When connected to a network, "NETWORK CONTROL" will
normally be displayed on the unit's monitor output. When
ON
playback is performed via the network, this will also be
displayed on the unit's monitor. Operation via the unit will not be
(DISPLAY:
possible while network connected.
ON)
However, it will be possible to terminate the network connection
by pressing and holding the [EXIT/OSD] button for at least 3
seconds.
When connected to a network, "NETWORK CONTROL" is not
displayed on the unit's monitor output. Even if playback is
performed via the network, the unit's monitor output will be
ON
normally displayed for monitoring. The unit's PLAY/STOP
indicator will not light up even during playback. (Recording will
(DISPLAY:
be possible.)
OFF)
Operation via the unit will not be possible while network
connected. However, it will be possible to terminate the network
connection by pressing and holding the [EXIT/OSD] button for
at least 3 seconds.
4
Move the cursor to "IP ADDRESS" and
press the [ ] button, then press the
[ ], [ ], [ ], and [ ] buttons to
change the setting.
(Example: 192.168.0.1)
]
5
Move the cursor to "SUBNET MASK"
and press the [ ] button, then press the
[ ], [ ], [ ], and [ ] buttons to
change the setting.
(Example: 255.255.255.0)
77
] button [ ] button
[EXIT/OSD] button
Description