Table of Contents
Advertisement
1
PREPARING FOR USE
Changing the position of the
operation display area
1
Press the [EXIT/OSD] button repeatedly.
Pressing the [EXIT/OSD] button repeatedly lets you move
or erase the operation display area.
Example: Normal screen
Operation
display area
Built-in hard disk
Hard disk recording area
When an unused hard disk is installed, the initial
recording area settings (normal recording area 80%,
alarm recording area 19%, archive area 1%) are
automatically set at recorder power ON.
When a hard disk with set recording areas is installed,
the set recording areas are used for recording.
You can check the recording areas of a set hard disk by
selecting "3. RECORDING AREA SET" from the menu.
When installing a hard disk that was used by another
DVR, check the recording area settings.
[B] Alarm recording area
1%
19%
Hard disk's recording area
[EXIT/OSD] button
01- 01 - 04
00: 00 : 00EN
10FPS
[C] Archive area
80%
[A] Normal recording area
[A] Normal recording area
Recording
mode
Normal
Manual
recording
Timer
Automatic
recording
[B] Alarm recording area
Recording
mode
Alarm
Automatic
recording
Pre-alarm
Automatic
recording
[C] Archive area
Recording
mode
Copy
Manual
Selecting the recording method
If you want to record images while monitoring;...... P. 23
If you want to record with an end time specified
using timer settings;............................................... P. 23
If you only want to record when an intruder is
present;............................................................ P. 24, 67
If you also want to record images from before the
intruder appears; ................................................... P. 25
20
[A]
[B]
[C]
Recording method
During monitoring, recording is
performed when the [REC/STOP]
button is pressed.
Recording is carried out in
accordance with timer settings.
Recording method
Recording is carried out in
accordance with alarm recording
settings. Specifically, alarm images
are recorded in the alarm recording
area in response to operation of the
switch that has been installed for the
alarm input terminal or to detection of
an intruder or the like using motion
sensors.
Recording is carried out in
accordance with pre-alarm settings.
Specifically, the same images as
recorded normally over a preset time
interval are repeatedly overwritten in
the alarm recording area until an
alarm occurs. Pre-alarm recording
can be setup to have the digital video
recorder record alarm images before
an alarm input is detected.
Recording method
This area is used to copy important
images from the normal recording
area and alarm recording area. By
making changes to the normal
recording area and the alarm record-
ing area, this area can be extended to
up to 10 GB automatically.
English
Advertisement
Table of Contents
