ABB PST30 Installation And Maintenance Manual page 49

Top level
Settings
Application setting
Basic settings
Functional settings
Presentation settings
Service settings
All settings
Changed settings
Reset all settings
Operation mode
Figure 23: Functional Settings menu
Settings
Functional settings
Figure 24: Start/Stop group
Low Voltage Products & Systems
ABB nc. • 888-385-1221 • www.abb-control.com
Chapter 7
Settings and configuration
7:2.4 Functional Settings
The Functional setting menu consists of groups with parameters arranged by function
such as protection, warning, fault, fieldbus communication etc. This menu should be
used if a more advanced set-up is required. For a detailed description of each param-
eter, see Chapter 10 " Functions" .
Enter the Functional settings
Enter the menu by selecting Functional Settings.
7:2.4.1 Start/Stop
To set parameters related to start and stop, enter the Start/Stop group. The following
Start / Stop
parameters are available in this group:
• Setting I
Protections
• External By-Pass
Warnings
• Start ramp
• Stop ramp
Faults
• Initial voltage
• End voltage
Inputs
• Step down voltage
Outputs
• Current limit level
• Kick start
Fieldbus
• Kick level
Seq. Start
• Kick time
• Start range
• Stop range
To set parameters from Setting I
Kick Start
Activate the Kick Start function by entering this menu. Press Store to save the
selection.
Kick Level
Set the required level of the Kick Start. Press Store to save the data.
This menu will only be visible if Kick Start is activated.
Kick Time
Set the required time for the kick start. Press Store to save the data.
This menu will only be visible if Kick Start is activated.
Start Range
The ramp time for start can be set between 1 and 30 seconds as default. If required,
the range can be extended up to 120 seconds by entering this menu. Press Store to
save the data.
Stop Range
The ramp time for stop can be set between 0 and 30 seconds as default. If required,
the range can be extended up to 120 seconds by entering this menu. Press Store to
save the data.
The configuration of the parameters in the Start/Stop group is now completed. It is pos-
sible to return to top level by pressing Back three times. To configure the protections,
proceed to that menu.
e
to Current limit level, see "Basic Settings".
e
7
7.11
1SXU 132 021 M0201