Operating Procedure - Mitsubishi Electric MELDAS 600 Series Instruction Manual

4.2 Operating procedure
1) Toot selection
Select "1) Memory Back Up" from the M6 Maintenance Tool main screen. (Refer to the section titled
'Main Menu" for details).
2) Tool menu screen
The following menu appears.
ht**m*nm****+H)L MEMORY BACK UP COMMAND p
[Memory List] :
Bus
Card Mem Size Mem Size
__________--_______----------------------------
OnBoard HRI 138 From: 0x800000 Sram: 0x080000
C-Bus#l HR437B From: 0x400000 Sram: 0x200000
C-Bus#2 HR437B From: 0x400000 Sram: Ox200000
[Command] :
Q) Quit
0) Restart
1) Write (Memory -> Backup)
2) Read (Backup -> Memory)
3) Compare (Memory c> Backup)
4)
Clear (Memory)
5) Create Info Area
6) Delete info Area
7) Show Info Area
[Select Mem#] :
1 - OnBoard FROM 2 - OnBoard SRAM
3 - C-Bus#l FROM 4 - CBus#l SRAM
>[Command] [Select Mem#l, [Blk#1
> 1 2 [Enter]
@ [Memory List]
This displays the FROM and SRAM size of the CPU, the FROM
and the FROM and SRAM size of C-BUS #2.
and SRAM size of C-BUS #1 ,
0 [Command]
This displays the memory backup tool command. Refer to the explanations of the commands
on the following pages for details.
@I [Select Memory]
This displays the memory in which the data is backed up.
1 - On-board FROM . . . . . . . . . . . . . . On-board FROM
2 - On-board SRAM . . . . . . . . . . . . . . . On-board SRAM
3 - C-Bus#l FROM . . . . . . . . . . . . . . . . C-Bus#l FROM
4 - C-Bus#l SRAM . . . . . . . . . . . . . . . . C-Bus#l SRAM
@I [Command], [Select Mem#], [Blk#]
> COMMAND A MEMORY SELECTION NO., BLOCK NO. [Enter]
COMMAND:
\ Space
code
Set a command No. shown in [Command].
MEMORY SELECTION NO.:
Set
the No. of a memory shown in [Select Mem#]. This parameter is used for the Write,
Read, and Compare commands.
BLOCK NO.:
Set this only when on-board SRAM is selected as the memory, and an HR Series ROM
cassette (cassette with a larger capacity than the on-board SFtAM) is
used as the backup
cassette. Always designate the block No. when creating an information area.
-7-