Write From - Mitsubishi Electric MELDAS 600 Series Instruction Manual

7.5.6 Write FROM
Command : w <Address l>, <Address 2>, <Size>
<Address l> : Memory address that is the writing source.
<Address 2> : FROM memory address that is the writing destination.
<Size> : Erase and write size.
: This command is used to write to the FROM. Only the amount (-Size>) of details in
<Address 1 > are written to FROM (<Address 2>).
Note that <Address> and <Size> should be designated following the restrictions
Explanation
below.
Restrictions
Designate a 4-byte boundary
address.
Settina examole I
<Address 2> becomes the FROM
address.
Designate the cassette size
for
the QX Series FROM cassette.
Designate a multiple of 128KB for
the HR
Series FROM cassette.
OxaaOOOOOO - OK
OxaaOOOOO1 - NG
OxaaOOOO02 -kG
OxaaOOOO03 - NG
OxaaOOOO04 - OK
QX812 is 256Kl3, so the setting is
0x40000.
QX815 is 2MB, so the setting is
0%200000.
Numbers divisible by 128K (Ox2OOrlOO)
such as Ox2OOOCl,Ox4oOOO. 0x60000,
oxaoooo, . . . oiaooooo, etc.
Example:
1) Write the on-board FROM (8MB) details to the backup cassette (HR401).
>w Oxae000000,0xaa40000O,Ox8OOOOO [Enter]
2) Write the on-board SRAM (512MB) details to the backup cassette (HR401).
>w 0xa8000000,0xaa400000,0x80000 [Enter1
3) Write the FROM (4MB) of the cassette mounted on C-BUS #l to the backup cassette (HR401).
>w 0xac400000.0xaa400000.0x400000 IEnter]
4) Write the SRAM (2MB) of the cassette mounted on C-BUS #l to the backup cassette (HR401).
>w>l
(Supplement) Refer to the section titled "Memory map' for details about example addresses.
-32-