Mitsubishi Electric MELDAS 600 Series Instruction Manual page 16

5) Cre.ate Info Area
This command is used to set the information area. In this way a comment and date can now be
added to the backup data.
(Caution) The information area is assigned to the block #O region. Any data already written to
block #O will be erased by this operation, so be careful. Information areas can only be
created when backina UD the on-board SRAM. usina an HR Series (1 MB or more of
memory] cassette as the backuo cassette.
The following shows an execution example.
93 fEnter]
Create Info Area ? [YES:Y(y) / NO:N(n)] --> y fEnten
Erase
]>>I
Programming
fl
Compare
OK
... a)
... b)
... c)
- e)
,.. 9
>
a) The Create Info Area command is executed.
b) This is for confirming the execution. The Create Info Area execution begins if Y is selected.
c) ihe FROM block #0 region is erased.
d) The information data is written to the FROM block #0 region.
e) The FROM block #0 is compared with the original data.
9
"OK" is displayed if the writing finishes correctly.
6) Delete Info Area
This command is used to delete the information area. In this way the block #O can now be used for
memory backup.
The following shows an execution example.
>6 fEnter]
Delete Info Area i [yES:Y(y) / NO:N(n)] --> y=]
Programming
0
Compare
OK
>
a) The Delete Info Area command is executed.
b) This is for confirming the execution. Delete Info Area begins if Y is selected.
c) The information data is deleted.
d) The written data is compared with the original data.
e) ,'OK" is displayed if the writing finishes correctly.
- iP