Stopping The Drive - ABB ACS580MV Quick Manual

1. Enable the local control mode of the control panel by pressing the Loc/Rem key (1).
2
1
The drive is in state Stopped and the display shows
2. Enter the setpoint. See
3. Press the Start key (2) to start the motor.
After the motor has been magnetized, the motor speed ramps up to the setpoint.
While the motor is accelerating, the run status indication on the display blinks. When
the motor speed has reached the setpoint, the run status indication lights up
permanently.

Stopping the drive

This section describes how to stop the drive using the local operator panel of the drive. If
the drive is remotely-controlled, follow the established shutdown procedures.
For details on using the local control panel see
manual".
"ACS-AP-X assistant control panels user's
"ACS-AP-X assistant control panels user's
Operation 33
.
manual"