...by fork-lift or pallet truck
...on rollers
(Not allowed with Marine versions)
Laying the unit on its back
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Cabinet back panel
Support
The centre of gravity may be quite high. Be therefore careful
when transporting the unit. Tilting the cabinets must be
avoided.
The units are to be moved only in the upright position.
If using a pallet truck, check its load capacity before
attempting to move the unit.
Remove the wooden bottom frame which is part of
the shipment.
Lay the unit on the rollers and move it carefully until
close to its final location.
Remove the rollers by lifting the unit with a crane,
fork-lift, pallet truck or jack as described above.
If the cabinet needs to be laid on its back, it
must be supported from below beside the
cubicle seams as shown.
Notes:
• Transportation of a unit on its back is only
allowed if the unit is equipped for such
transportation at the factory.
• Never lay or transport a unit with sine filters
(i.e. with option code +E206) on its back.
41
Mechanical installation