ABB 2CSYK1201C Product Manual page 39

MYLOS Building Automation
®
Heating setpoint reduction night operation
Options:
- 0.5 K
- 1.0 K
- ...
- 4 K
- ...
- 8.0 K
The setting "Heating setpoint reduction night operation" allows you to specify the number of degrees Kelvin that the
comfort temperature is lowered during night mode.
This parameter is only available if the parameter "Selection of base setpoint" (tab "Setpoint general") is set to
"dependent setpoints".
Cooling setpoint comfort mode
Options:
- 16.0 °C
- 16.5 °C
- ...
- 23.0 °C
- ...
- 31.0 °C
The "Cooling setpoint comfort mode" specifies the individual comfort temperature for the cooling mode. This parameter
is only available if the "Cooling" or "Heat and cool" control functions are used, in which the setpoints "dependent
setpoints" (tab "Setpoints general") have been selected.
Cooling setpoint increase standby
Options:
- 0.5 K
- 1.0 K
- ...
- 2 K
- ...
- 8.0 K
The setting "Cooling setpoint increase standby" allows you to specify the number of degrees Kelvin that the comfort
temperature is increased during standby operation.
This parameter is only available if the parameter "Selection of base setpoint" (tab "Setpoint general") is set to
"Dependent setpoints".
Cooling setpoint increase night mode
Options:
- 0.5 K
- 1.0 K
- ...
- 4 K
- ...
- 8.0 K
"Cooling setpoint increase night mode" allows you to specify the number of degrees Kelvin that the comfort temperature
is raised during night operation. This parameter is only available if the parameter "Selection of base setpoint" (tab
"Setpoint general") is set to "Dependent setpoints".
Commissioning
MYLOS Building Automation | Commissioning 39
®