Fujitsu M10 Product Notes page 30

Perform the ordinary replacement procedure.
- If the setting specifying the XSCF as an NTP client is enabled:
1. Disconnect the LAN cable from the XSCF-LAN port and then perform
2. After the XSCF starts, connect the serial cable to the serial port.
3. Execute the setdate(8) command to set the XSCF time.
4. Connect the LAN cable to the XSCF-LAN port.
5. Execute the version command to confirm the firmware version information.
XSCF> version -c xcp -v
BB#00-XSCF#0 (Master)
XCP0 (Current): 2011
CMU : 02.01.0001 (*1)
POST : 1.20.0
OpenBoot PROM : 4.34.0+1.2.0
Hypervisor : 0.21.11
XSCF : 02.01.0001
XCP1 (Reserve): 2011
CMU : 02.00.0006 (*2)
POST : 1.13.0
OpenBoot PROM : 4.34.0+1.0.5
Hypervisor : 0.21.3
XSCF : 02.01.0001
CMU BACKUP
#0: 02.01.0001
#1: ..
XSCF>
6. Execute the testsb command to confirm that the FRU requiring maintenance is
XSCF> testsb -a
7. Execute the showstatus command to confirm that the FRU is operating
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240 ･ March 2015
16
replacement.
Do not connect the LAN cable at this time.
After this, the XSCF is reset.
If the XCP firmware version does not match that used before the replacement,
update the firmware. For details, see "16.1.3 Updating firmware" in the
Fujitsu M10/SPARC M10 Systems System Operation and Administration Guide.
If you replace the microSD card, the CMU firmware versions do not match.
However, you do not need to perform an update. The following example
shows "02.01.0001" (*1 in the execution example) as the CMU firmware version
of the current XCP, and "02.00.0006" (*2 in the execution example) as the CMU
firmware version of the reserve XCP. Thus, you can see that the CMU
firmware versions do not match.
recognized normally.
normally after the completion of maintenance.
Nothing is displayed in the normal state.