Jp-Pkt-Size (Ipv6 Pim View) - HP 3600 v2 Series Command Reference Manual
Ip multicast
Hide thumbs
Also See for 3600 v2 Series:
- Command reference manual (510 pages) ,
- Configuration manual (449 pages) ,
- Security configuration manual (398 pages)
Table of Contents
Advertisement
undo holdtime join-prune
View
IPv6 PIM view
Default level
2: System level
Parameters
interval: Join/prune timeout time in seconds, with an effective range of 1 to 65,535.
Description
Use holdtime join-prune to configure the global value of the join/prune timeout time.
Use undo holdtime join-prune to restore the default.
By default, the join/prune timeout time is 210 seconds.
Related commands: holdtime assert, pim ipv6 holdtime assert, and pim ipv6 holdtime join-prune.
Examples
# Set the global value of the join/prune timeout time to 280 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] holdtime join-prune 280
jp-pkt-size (IPv6 PIM view)
Syntax
jp-pkt-size packet-size
undo jp-pkt-size
View
IPv6 PIM view
Default level
2: System level
Parameters
packet-size: Maximum size of each join/prune message in bytes, with an effective range of 100 to
64000.
Description
Use jp-pkt-size to configure the maximum size of each join/prune message.
Use undo jp-pkt-size to restore the default.
By default, the maximum size of each join/prune message is 8100 bytes.
If IPv6 PIM snooping–enabled switches are deployed in the IPv6 PIM network, be sure to set a value no
greater than the IPv6 path MTU for the maximum size of each join/prune message on the receiver-side
edge IPv6 PIM devices.
Related commands: jp-queue-size.
382
Advertisement
Table of Contents
