Entry-Limit (Mld-Snooping View) - HP 3600 v2 Series Command Reference Manual

Default level
2: System level
Parameters
dscp-value: Specifies the DSCP value for MLD messages, in the range of 0 to 63.
Description
Use dscp to set the DSCP value for MLD messages.
Use undo dscp to restore the default.
The default DSCP value in MLD messages is 48.
This command applies to only the MLD messages that the local switch generates when the switch or its
port acts as a member host, rather than those forwarded ones.
Examples
# Set the DSCP value to 63 for MLD messages.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] dscp 63

entry-limit (MLD-snooping view)

Syntax
entry-limit limit
undo entry-limit
View
MLD-snooping view
Default level
2: System level
Parameters
limit: Specifies the maximum number of entries in the MLD snooping forwarding table. For the HP 3600
v2 EI switches, the value ranges from 0 to 1000. For the HP 3600 v2 SI switches, the value ranges from
0 to 512.
Description
Use entry-limit to configure the maximum number of entries in the MLD snooping forwarding table
globally.
Use undo entry-limit to restore the default.
By default, the upper limit is 1000 for the HP 3600 v2 EI switches, and 512 for the HP 3600 v2 SI
switches.
Related commands: multicast-vlan ipv6 entry-limit.
Examples
# Configure the MLD snooping forwarding table to contain at most 512 entries.
<Sysname> system-view
[Sysname] mld-snooping
258