Jp-Queue-Size (Pim View); Pim - HP 3600 v2 Series Command Reference Manual

[Sysname] pim vpn-instance mvpn
[Sysname-pim-mvpn] jp-pkt-size 1500

jp-queue-size (PIM view)

Syntax
jp-queue-size queue-size
undo jp-queue-size
View
Public network PIM view, VPN instance PIM view
Default level
2: System level
Parameters
queue-size: Maximum number of (S, G) entries in a join/prune message, in the range of 1 to 4096.
Description
Use jp-queue-size to configure the maximum number of (S, G) entries in a join/prune message.
Use undo jp-queue-size to restore the default.
By default, a join/prune messages contains a maximum of 1020 (S, G) entries.
When you use this command, take the following into account:
The size of the forwarding table. In a network that does not support packet fragmentation, if you
•
configure a large queue size, a join/prune message might contain a large number of groups, which
might cause the message length to exceed the MTU of the network. As a result, the products that do
not support fragmentation will drop the join/prune message.
• The (S, G) join/prune timeout time on the upstream device. If you configure a small queue size, the
outgoing interface of the corresponding entry might have been pruned because of timeout before
the last join/prune message in a queue reaches the upstream device.
Related commands: holdtime join-prune, jp-pkt-size, and pim holdtime join-prune.
Examples
# Configure a join/prune message to contain a maximum of 2000 (S, G) entries in the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] jp-queue-size 2000
# Configure a join/prune message to contain a maximum of 2000 (S, G) entries in VPN instance mvpn.
<Sysname> system-view
[Sysname] pim vpn-instance mvpn
[Sysname-pim-mvpn] jp-queue-size 2000

pim

Syntax
pim [ vpn-instance vpn-instance-name ]
151