Shutting Down And/Or Re-Starting The Rcp Computer; Shutting Down The Rcp Computer; Shutting Down And Restarting The Rcp Computer; Re-Calibrating The Touch Screen - Canon BU 45 User Manual

Canon BU 45 Camera Control System User's Manual

Shutting Down and/or Re-Starting the RCP Computer

The RCP computer must be shut down and re-started after certain operations (such as
disabling or restarting the Enhance Write Filter) are performed.
The RCP computer is shut down whenever the RCP power switch is turned off.
However, this also shuts down the touch screen, which must then be re-started
(by pressing the touch screen power button) when the RCP is re-started.

Shutting Down the RCP Computer

1.
Display the RCP Configuration screen (page 24), then select the
button. The RCP computer is shut down, but the touch screen remains on.

Shutting Down and Restarting the RCP Computer

1.
Display the RCP Configuration screen (see page 24 for instructions).
2.
Select the
touch screen on.

Re-Calibrating the Touch Screen

The touch screen should be re-calibrated if the touch points on the screen do not
coincide with the elements of the user interface.
The touch screen is calibrated at the factory. Re-calibration is not necessary
unless a button or other element does not respond when it is touched.
1.
Display the RCP Configuration screen (see page 24 for instructions).
2.
Select the
3.
Follow the instructions that are displayed on the screen. The RCP computer
is automatically shut down and restarted when the re-calibration is
completed.
32
button to shut down and restart the CPU while leaving the
button.