Configuration Screens; Rcp Operating System And Software; Rcp Mounting Configurations - Canon BU 45 User Manual

Introduction

Configuration Screens

Two configuration screens (the RCP Configuration screen shown on page 25, and the
Camera Loading screen shown on page 28) allow the operator to specify IP address
information for the RCP, specify the length of inactivity time before the screen saver is
displayed, assign cameras to the RCP, and assign a name for each camera.
Refer to the Installation and Setup section of this manual for a detailed description of
each configuration screen and instructions for their use.

RCP Operating System and Software

® ®
The Telemetrics RCP utilizes an embedded Microsoft Windows XP operating system
to provide a familiar user interface for ease of integration and maintenance.
The RCP includes the Windows XP Enhanced Write Filter (EWF) to protect the
operating system and RCP software programs from write access, eliminating the threat
from viruses. The EWF can be turned off by the operator when necessary (such as when
updating a driver) and then turned back on.
The operating system and RCP software are installed on a removable compact flash
hard drive, allowing the operating system and RCP software to be readily replaced or
updated by simply replacing the compact flash hard drive.

RCP Mounting Configurations

The Telemetrics RCP is provided in either a desktop or rack-mounted configuration
(Figure 5). Each configuration provides the same physical layout and identical controls
and touch screen.
Desktop Configuration
Rack-Mounted Configuration
Figure 5 Telemetrics RCP Mounting Configurations
13