Canon BU 45 User Manual page 29

3.
Local Area Connection: Enter information about the main network card on
the RCP:
Select the IP Address box, then type the IP address of the main network
a.
card.
Select the Subnet Mask box, then type the subnet mask address of the
b.
main network card.
Select the Default Gateway box, then type the default gateway address of
c.
the main network card.
If the MAC box is not automatically populated, select the MAC box, then
d.
type the media access control address for the main network card.
If the dynamic host configuration protocol (DHCP) is to be used for the
e.
main Ethernet connection to the RCP, select the DHCP check box to
place a check mark in it. Otherwise, leave the check box blank.
4.
Backup Local Area Connection: Enter information about the backup
network card on the RCP:
Select the IP Address box, then type the IP address of the backup
a.
network card.
Select the Subnet Mask box, then type the subnet mask address of the
b.
network card.
Select the Default Gateway box, then type the default gateway address of
c.
the backup network card.
If the MAC box is not automatically populated, select the MAC box, then
d.
type the media access control address for the backup network card.
If the dynamic host configuration protocol (DHCP) is to be used for the
e.
backup Ethernet connection to the RCP, select the DHCP check box to
place a check mark in it. Otherwise, leave the check box blank.
5.
Screen Saver Time: Select the
length of inactivity time (in minutes) before the screen saver is displayed.
6.
Select the
must be shut down and restarted to complete the configuration process.
Select the
Configuration screen without saving the information.
or
button to save the configuration information. The RCP
button to cancel display of the RCP
Installation and Setup
button to increase or decrease the
27