Samsung Officeserv 7100 Technical Manual page 80

OfficeServ 7100
TECHNICAL MANUAL
Notes:
Centralized attendant handles second level recalls across the network. This is
•
not to be confused with centralized operator which handles calls from remote
stations dialing 0.
Centralized attendants can only be assigned on a per node basis. Each node in
•
the network can have a local attendant or a centralized attendant, but not both.
Attendant recall destination can be changed by time of day by selecting ring
•
plans and recall destinations in MMC 825.
This feature is supported over Q-sig and IP networking.
•
MMC INFORMATION:
MMC 825: USE CENT ATT: RING1-6, YES/NO). This is used to set each node to use
attendant of a remote system.
MMC 825: (REMOTE ATTN NUM:RING1-6, XXXX). This is used to assign the station
number or attendant group of the remote attendant that second level recalls will be
routed.
MMC 501:
(E-HOLD RECALL TM) This timer controls the duration of time a call is held
exclusively at a station before recalling.
(SYS HOLD RECALL) This timer determines the time calls can be left on hold before
recalling back to the holding station. This is a system-wide timer. Setting timer to
000 will defeat this feature and no recalling will take place.
(TRANSFER RECALL) This timer determines the time transferred calls ring before
recalling. This is a system-wide timer.
(PARK RECALL TIME) This timer controls the duration of time a call is parked before
recalling to the call park originator.
(CAMP ON RECALL) This timer controls the duration of time a camped-on call will
stay at a destination before recalling to the transferring station.
(ATT. RECALL TIME) This is the length of time a transfer recall will ring at a station
before recalling the local operator or Centralized Attendant.
(RECALL WAIT TIME) This is the time any recall (hold or transfer) continues to recall
at your station before it recalls to the local operator or Centralized Attendant.
2.9.4
Table of Contents
Home Page
PROGRAMMING
PART 2 JANUARY 2009