Samsung Officeserv 7100 Technical Manual page 68

OfficeServ 7100
TECHNICAL MANUAL
• (0001~2000) : Index numbers.
• DIGIT : Beginning of digits for outgoing call. Because a networking call should
have a node number, it can be the starting point. It should be included in the
numbers assigned in MMC 824.
• LENGTH : The system does not send digits to the trunk, until "LENGTH" of
digits are collected.
RT : Route table number assigned in MMC 712.
e.g. for switch 001 the entries would be:
Digits Length
002
003
In order to receive incoming calls over the network the DID table must be set up.
MMC 711. LCR Time Table: IF YOU ARE NOT USING THIS TABLE, YOU MUST
STILL ENTER 0000 for HHMM and set LCRT=1.
Assigns 4 time zones for each date of the week for LCR.
The meaning of each field is as follows.
• SUN~SAT: Sunday to Saturday.
• A~D: 4 time zones.
• HHMM: Time in 24 hour mode.
• LCRT: Time table number used in MMC 712.
12. Make entries in the DID digit table MMC 714 for the digits to be received over the
network links.
MMC 714. DID Destination
Assigns an incoming DID call to a specific ring plan destination. The destination
includes a station, station group, trunk, trunk group, LCR number, and networking
dial number.
The meaning of each field is as follows.
• (001~999): Index numbers.
• DGT: Numbers which will be received. '*' means any digit between '0'~'9'.
• MOH SOURCE: Assigns MOH which will be used according to the received
number. If None, it works according to MMC 409.
•
1~6 : Assigns a specified station or group which will receive the call according
Route
7 2
7 3
2.8.7
Table of Contents
Home Page
SPECIAL APPLICATIONS
PART 2 JANUARY 2009