Removing The Cover - Canon CXDI-50C Service Manual

Removing the cover

2.3
Screw M3x8 (x15)
Base cover
Screw M3x8 (x11)
1. Remove the sleeve cover (x11).
2. Remove the screw (M3x8) or screw (M3x12).
3. Remove the insulation sleeve and base cover.
Note:
1. Handle with carefully so that the defect should not adhere.
2. The insulation sleeve and sleeve cover must not be lost.
3. The order of detaching the screws fixes the base cover is not asked especially. At assembling,
check the screw length, tight the screws evenly and be careful not to tighten it so much.
[Replacing Base Cover]
As the operation division was relocated, the base cover plate of CXDI-50G has been renewed.
As a result, there are two types of nameplate. Only the manufacture is authorized to change the
description of the plate according to the Pharmaceutical Law in Japan. You need to use the
place with the same address as the previous plate when replacing.
This is required only for Japanese market. Both of old and new plates are interchangeable for
the other countries.
*Application
CXDI-50G 7M
3M
4. Repair Guide
Body No. 150079 -
Body No. 250001 -
Screw M3x12 (x15)
CXDI-50C 7M
3M
6
Sleeve cover (x11)
Insulation sleeve (x11)
Sleeve cover (x11)
Insulation sleeve (x11)
Body No. 100009 -
Body No. 200001 -