Fuel System; Fuel Pipe Removal And Installation - Suzuki Liana RH418 Supplementary Service Manual

Fuel System

Fuel Pipe Removal and Installation

WARNING
!
Before servicing fuel system, be sure to
observe "Precautions on Fuel System
Service in related manual".
Removal
1) Relieve fuel pressure in fuel feed line according to
"Fuel Pressure Relief Procedure in related manual".
2) Disconnect negative cable at battery.
3) Disconnect fuel pipe joint and fuel hose from fuel
pipe at the front and rear of each fuel pipe.
For quick joint (2), disconnect it as follows:
a) Remove mud, dust and/or foreign material
between pipe (1) and joint by blowing
compressed air.
b) Unlock joint lock by inserting special tool
between pipe and joint.
Special tool
(A): 09919-47020
c) Disconnect joint (2) from pipe (1).
Repair Instructions
4) Disconnect brake pipe from pipe joint.
S3RH0B1706005
5) Mark the location of clamps (1) on fuel pipes (2), so
that the clamps can be reinstalled to where they
were.
6) Remove pipes (2) with clamp (1) from vehicle.
7) Remove clamp (1) from pipes (2).
Installation
1) Install clamps to marked location on pipes. If clamp
is deformed or its claw is bent or broken, replace it
with new one.
2) Install pipes with pipe clamps to vehicle.
3) Connect fuel hoses and pipes to each pipe.
CAUTION
!
When connecting joint, clean outside
surfaces of pipe where joint is to be inserted,
push joint into pipe till joint lock clicks and
check to ensure that pipes are connected
securely, or fuel leak may occur.
4) With engine OFF, turn ignition switch to ON position
and check for fuel leaks.
I3RH0B170001-01
Fuel System:
2
1
I2RH01170007-01
1G-1