Pistons, Piston Rings And Connecting Rods Components - Suzuki Liana RH418 Supplementary Service Manual

• Spring squareness:
Use a square and surface plate to check each spring
for squareness in terms of clearance between end of
valve spring and square. Valve springs found to
exhibit a larger clearance than limit must be replaced.
Valve spring squareness
Limit: 1.6 mm (0.063 in.)
Pistons, Piston Rings and Connecting Rods
Components
I2RH01140144-01
1. Top ring
2. 2nd ring
3. Oil ring
4. Piston
5. Connecting rod
: See "A"
6. Connecting rod bearing cap
: See "B"
7. Connecting rod bearing
8. Piston pin
9. Piston pin circlip
10. Bearing cap nut
: Tighten 15 N⋅m (1.5 kgf-m, 11.0 lb-ft), 45° and 45° by the specified
procedure.
: Tightening torque
: Apply engine oil to sliding surface of each part.
: Do not reuse.
"A": Apply engine oil to sliding surface except inner surface of big end,
and rod bolts. Make sure rod bolt diameter when reuse it due to
plastic deformation tightening. Refer to "Piston Pins and Connecting
Rods Inspection".
"B": Point arrow mark on cap to crankshaft pulley side.
Engine Mechanical: 1D-45
S3RH0B1406029
I3RH0A140010-01