5 BOOTCODE AND FIRMWARE UPGRADE
4.
Fill the upgrade parameters in next pop-up windows
•
In firmware version previous to 1.70 the Enervista 650 Setup program requires the IP address of the relay under
upgraded and its serial number.
•
In versions 1.70 and higher it is also necessary to enter the ordering code for the relay. See figure below.
5.
If the relay is not an enhanced model or control functionality then click the Upgrade Firmware button to continue the
process (figure below).
Figure 5–25: FIRMWARE UPGRADE ACCEPTANCE WINDOW
GEK-113000AE
Figure 5–24: RELAY SERIAL NUMBER
F650 Digital Bay Controller
5.1 UPGRADE FROM VERSION BELOW V7.00.
5
5-13