Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 43

Table 2-25 Factory default setting for IP address (IPv4)
Module
Management module
Server blade 0 – 7
Switch module 0
Switch module 1
Switch module 2
Switch module 3
Note:
• When the default account (operator, no password) of the IP address for
Hitachi 1 Gb/sec LAN switch module (20-port) and Hitachi 1/10 Gb/sec
LAN switch module, version 10.7.H or earlier for both, or for Hitachi 1
Gb/sec LAN switch module (40-port) version 11.6 or earlier is deleted, set
the switch module authentication information (account, password, and
administrator password) through the console of management module. If
you do not set the switch module authentication information, IP address
setting will fail.
• Do not change the IP address of Brocade 10 Gb/sec DCB switch module,
Brocade 8 Gb/sec Fibre Channel switch module, and Brocade 16 Gb/sec
Fibre Channel switch module through the switch module console. When
you change the IP address, the IP address is overwritten to the setting of
management module while restarting the switch module or turning on/off
the power.
• When a value other than 0.0.0.0 is set as the default gateway of Hitachi 1
Gb LAN switch module (20-port, 40-port) and Hitachi 1/10 Gb LAN switch
module, the setting value will be added after all default gateways without
interface specified are deleted. If you need to have the default gateway
specified to VLAN ID, set the default gateway with VLAN ID specified. If
you need to set multi-path, set the default gateway to 0.0.0.0, directly
log in to the LAN switch module console, and set the default gateway.
• When you change the default gateway of Hitachi 1 Gb LAN switch module
(20-port, 40-port) and Hitachi 1/10 Gb LAN switch module to a value
other than 0.0.0.0 and then return it to 0.0.0.0 or change the switch
module connection type to other than Management LAN, the management
module does not delete the default gateway setting. Thus, you need to
directly log in to the LAN switch module console to delete the default
gateway setting.
• When Network OS version 3.0.0 runs on a Brocade 10 Gb DCB switch
module, the default gateway setting from the management module does
not take effect on the DCB switch module. Log in to the DCB switch
module and configure it using the ip route command. For details, see the
Network OS Administrator's Guide . If Network OS version 2.0.1 runs on a
Brocade 10 Gb DCB switch module, you cannot configure the gateway.
Hitachi Compute Blade 500 Series Management Module Setup Guide
IP address Subnet mask
192.168.0.1 255.255.255.0
0.0.0.0 0.0.0.0
192.168.253.35 255.255.255.240
192.168.253.36 255.255.255.240
192.168.253.37 255.255.255.240
192.168.253.38 255.255.255.240
Functional detail
Default gateway
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
2-19